Familiarisation
1. Temperature control (at rear)
2. Removable shelf
3. Adjustable foot
4. Door
5. Vapouriser
Before using for the first time
– Remove any exterior and interior packaging materials completely, including the adhesive strips.
– Before it is connected to the mains, the unit must be thoroughly checked for transport damage,
including its power cord.
– Clean the unit according to the instructions given in the De-frosting and cleaning section below.
– To ensure proper functioning, wait for around 2 hours before connecting the unit and switching
it on once it has been positioned.
– When the unit is first switched on, a slight smell may be noticed. However, this will disappear
once the cooling process has begun.
Installation
The appliance should be set up in a well-ventilated, dry room.
It should be operated in an ambient temperature of 16 to 32 °C and a relative humidity of max.
70 %.
Do not use the appliance outdoors.
Ensure that the plug is accessible and can be removed from the wall socket at any time.
Do not expose the appliance to direct sunlight, and do not position it next to any heat sources
(radiators, cookers etc). If this cannot be avoided, however, suitable insulation must be in
installed between the heat source and the unit.
The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or
similar object .
In the case of uneven floors, the adjustable foot on the unit can be used to compensate and
ensure optimum stability.
Vent ilat io n
Ens ure that there is enough space around the unit so that the air circulation round and behind it is
not obstructed. (Rear and sides 5 cm, top 10 cm.)
Reversible door
If required, the door may be reversed, i.e. from right-hinged (default installation) to left-hinged.
Warning: Always disconnect the unit from the mains before any maintenance or repair work is
carried out.
1. Remove the hinge cover (1).
2. Use a suitable pointed tool to remove the cover (5).
3. Use a suitable screw-driver to remove the two screws (2) holding the upper hinge (3) to the
housing.
4. Carefully lift up the door and place it on a soft surface to protect it from scratches.
5. Remove the blind covers for the hinge mounting holes (9) and fit it in the corresponding place
13
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals