Severin ES 3559 User Manual download pdf (Page 7)

rich juices to be extracted from fruit and

vegetables.

-

To preserve the maximum vitamin

content, the juices are best drunk fresh, ie

immediately after extraction.

To store, place the fresh juice in the

refrigerator in a covered container.

-

It is advisable to use glass or plastic

containers, since metal containers might

affect the taste.

-

After cleaning, cut up the fruit or

vegetable so that it fits down the feeder

tube. Before extracting juice from fruit or

vegetables with stones, please remove

any stones to prevent damage to the

appliance; in addition, removing the

cores optimises the juice extraction.

-

The following fruits and vegetables are

not suitable for juice extraction: figs,

grapes, avocados, aubergines,

raspberries, blackberries, currants,

elderberries, rhubarb, blueberries,

cranberries, beetroot etc.

-

Tomatoes should be lightly carved in

with a knife before juice extraction.

-

Bananas should be added for aromatic

purposes only, as very little juice can be

extracted.

Short-time operation

The appliance has been designed for short-

term operation only, i.e. it should not be

operated continuously for more than 1

minute. Switch off the appliance afterwards

and allow the motor to cool down for 1

minute before switching it on again.

Before using for the first time

-

Before the appliance is used for the first

time, it must be cleaned as described in

the section General Care and Cleaning.

Switch

The appliance is equipped with a 3-position

switch.

0 appliance switched off

1 slow juice extraction

2 fast juice extraction

We recommend starting extraction with the

slow setting and switching to the faster

setting only when necessary.

Operation

-

Place the filter base onto the drive unit.

Ensure that the three locating points on

the filter base are properly aligned with

the three corresponding holes on the

drive unit.

-

Fit the filter and grating plate insert in the

filter base and push the insert down until

it is heard locking into place. It is

essential that the filter is properly locked;

otherwise, if it is not correctly connected

to the drive shaft, damage may occur

during operation. Check that the insert is

properly and securely fitted by manually

turning the filter and grating plate insert

slightly in a clockwise direction; if it can

be easily turned, it is correctly fitted.

-

Place the transparent lid onto the filter

base and use the two locking clamps to

lock the lid to the base; this will activate

the safety switch.

-

Place the juice container directly

underneath the juice outlet.

-

Place the pulp container underneath the

pulp outlet.

-

Insert the plug into the wall outlet and set

the switch to the required setting.

-

Feed the cleaned and pre-cut fruit or

vegetable pieces down the feeder tube

while the unit is running. Use the pestle

and lightly push the pieces down.

Excessive pressure may result in damage

to the motor or grating plate!

-

When processing large quantities of fruit

or vegetables, the pulp container and

juice container must be emptied from

time to time as necessary.

-

After use, switch the appliance off and

remove the plug from the wall socket.

Juice container

The juice container incorporates a

removable foam screen. If the juice is

poured through the screen located on the

5

1 2 3 4 5 6 7 8 9 10 11 12 ... 40 41

Comments to this Manuals

No comments